System components

The system is deliberately small: a set per water point, tube to connect it, and a few optional parts. Each page below lists the full specification, what is in the box and what it does and does not work with.

RL-SET-30

Protection set

30 nozzles, 2 circuits, one water point

The standard building block of a EleHalo system: everything needed to run two independent circuits from a single outdoor tap, designed to reduce ignition vulnerability across your roof and perimeter.

Specifications

RL-Y-2

Y-type dual outlet

Two protection sets on one high-pressure tap

Splits a single high-pressure tap into two independently valved outlets, so one tap can feed two protection sets.

Specifications

RL-PER-10

Perimeter protection set

30 nozzles, 2 circuits, ground-level install

The same 30-nozzle hardware as the protection set, packed and documented for a horizontal run along fences, terrace borders and mulch beds instead of a roof edge.

Specifications

RL-TUBE-20

Connection tube — 20 m pack

Short runs and top-ups

The smaller tube pack, used to top up a layout without paying for a full 50 m coil.

Specifications

RL-TUBE-50

Connection tube — 50 m pack

The economical bulk coil

The bulk coil for longer layouts; the configurator packs your runs into the least-waste combination of 20 m and 50 m packs.

Specifications

RL-IOT-1

Remote module

Start it from anywhere

Adds phone control and scheduling to a protection set, so the system can be started after you have already evacuated.

Specifications

RL-HOSE-1

Garden hose connector

For distant roof elements

Feeds a second water point from a standard garden hose, instead of running tube all the way around the house.

Specifications

RL-SET-20

Low-pressure protection set

20 nozzles, 1 circuit, one water point

The same building block as the standard set, sized for a low-pressure supply: everything needed to run one circuit from a single outdoor tap, designed to reduce ignition vulnerability across your roof and perimeter.

Specifications