RL-SET-30
Protection set
30 nozzles, 2 circuits, one water point
The standard building block of a EleHalo system: everything needed to run two independent circuits from a single outdoor tap, designed to reduce ignition vulnerability across your roof and perimeter.
One set covers one water point. It drives two circuits of up to 20 nozzles each, with a total of 30 nozzles across both, which is what an average-pressure domestic tap can supply without the last nozzle on a line going soft.
The nozzles are bendable brass. That forgives an uneven roof edge during a DIY install, and it lets you aim each nozzle away from sight lines so the system disappears once it is up.
Every nozzle adjusts from a fine atomising mist to a water column by turning the tip: left for mist, right for jet. Mist helps pre-wet vulnerable exterior surfaces; a directed jet can reach a far edge or gutter from a discreet position.
Used as part of a complete EleHalo layout, this set helps suppress landed embers and low-intensity spot fires and adds an active layer to defensible space and home hardening.
Specifications
- Nozzles included
- 30 brass, bendable, adjustable mist-to-jet
- Circuits
- 2 independent
- Max nozzles per circuit
- 20
- Water points served
- 1
- Nozzle spacing
- 1 per 2 m² flat roof · 1 per 1 m of saddle edge
- Recommended supply
- Average or high pressure (9 L bucket under 30 s)
What is in the box
- • 30 adjustable brass nozzles
- • Two-circuit manifold with shut-offs
- • 30 push-fit tees
- • 1 straight connector
- • 2 elbow connectors
- • 5 end plugs
- • 30 mounting clips
- • 30 UV-resistant straps
- • 1 thread-sealing tape
- • 30 m connection tube
- • Tap connector and thread adapters
- • Tube cutter
- • Personal & customized installation guide and configurator (delivered digitally)
Compatibility notes
- • Tubing is ordered separately — length depends entirely on your layout.
- • Needs one dedicated outdoor tap, or one half of a Y-type dual outlet on a high-pressure tap.
- • For a low-pressure supply, order the low-pressure set instead.
- • Works alongside the perimeter protection set on the same property, but each rail run needs its own circuit budget.
Installs on a regular 3/4" tap
No plumber and no permanent pipework. The system connects to an ordinary outdoor tap — the same one you use for your garden hose. Standard outdoor taps carry a 3/4" (G3/4) male thread, which is what the supplied tap connector is made for.
Many taps ship with a hose tip, nozzle or aerator screwed onto the end. In most cases you can simply unscrew that tip by hand (or with light pliers) to reveal the bare 3/4" thread. Wrap two or three turns of the included thread-sealing tape, screw the connector on hand-tight, and the tap keeps working normally for everyday use.
Smaller 1/2" taps, indoor mixer taps and washing-machine valves are covered by the included thread adapters. If your tap has an unusual or worn thread, the garden hose connector lets you feed the system from any standard hose fitting instead.
